Splice is the weakest location in the conveyor belt and it needs to be attended with care. Research made in improving the behavior of the splice under bulk loads, safety factor and reducing the splice length resulting in reduced cost. This was possible due to best quality splice material and accurate geometry. The result is less failure of splice and the low maintenance. Good quality splice joints leads to withstanding higher cycling loads without affecting the elongation properties and the

Converted raw rubber to finished product requires a process called vulcanization. Different methods of vulcanization are used to deliver finish products. Among these hot and cold vulcanization is the most effective. As the name suggests hot vulcanization takes place in the presence of steam and it does not yield the desired results. In the case of hot vulcanization the articles are set in a closed chamber supported by heated jackets inside autoclaves. The steam allows superior heat transfer